Application module: Assembly module design ISO/TS 10303-1636:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definition
   4.3 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

EXPRESS specification:

*)
SCHEMA Assembly_module_design_mim;

USE FROM Assembly_module_usage_view_mim;    --  ISO/TS 10303-1642

USE FROM Assembly_technology_mim;    --  ISO/TS 10303-1649

USE FROM Physical_component_feature_mim;    --  ISO/TS 10303-1721

USE FROM Physical_unit_design_view_mim;    --  ISO/TS 10303-1728

USE FROM Physical_connectivity_layout_topology_requirement_mim;    --  ISO/TS 10303-1826

USE FROM Physical_connectivity_definition_mim;    --  ISO/TS 10303-1755
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Assembly_module_usage_view_mim ISO/TS 10303-1642
Assembly_technology_mim ISO/TS 10303-1649
Physical_component_feature_mim ISO/TS 10303-1721
Physical_unit_design_view_mim ISO/TS 10303-1728
Physical_connectivity_layout_topology_requirement_mim ISO/TS 10303-1826
Physical_connectivity_definition_mim ISO/TS 10303-1755

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definitions

This subclause specifies the MIM entities for this module. The MIM entities and definitions are specified below.

5.2.1.1 assembly_module_design_view   EXPRESS-G

An assembly_module_design_view is a type of physical_unit that implements the ARM concept of Assembly_module_design_view. An assembly_module_design_view may be either a Layered_assembly_panel_design_view or a Layered_assembly_module_design_view.

EXPRESS specification:

*)
ENTITY assembly_module_design_view
  SUBTYPE OF (physical_unit);
END_ENTITY;
(*

5.2.1.2 component_mounting_feature   EXPRESS-G

A component_mounting_feature is a type of physical_component_feature that implements the ARM concept of Component_mounting_feature.

EXPRESS specification:

*)
ENTITY component_mounting_feature
  SUBTYPE OF (physical_component_feature);
END_ENTITY;
(*



*)
END_SCHEMA;  -- Assembly_module_design_mim
(*


© ISO 2018 — All rights reserved