Application module: Physical component feature | ISO/TS 10303-1721:2018-11(E) © ISO |
This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.
This clause constitutes the Module Interpreted Module (MIM) of the application module.
This clause also specifies the modifications that apply to the constructs imported from the common resources.
The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:
Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.
EXPRESS specification:
*)
SCHEMA Physical_component_feature_mim;
USE FROM
Component_feature_mim;
--
ISO/TS 10303-1657
(*
NOTE 1 The schemas referenced above are specified in the following part of ISO 10303:
Component_feature_mim ISO/TS 10303-1657
NOTE 2 See Annex D, Figures D.1and D.2 for a graphical representation of this schema.
This subclause specifies the MIM entities for this module. The MIM entities and definitions are specified below.
EXPRESS specification:
*)
ENTITY physical_component_feature
SUBTYPE OF (component_feature);
END_ENTITY;
(*
EXPRESS specification:
*)
ENTITY physical_component_terminal
SUBTYPE OF (component_terminal, physical_component_feature);
END_ENTITY;
(*
*)
END_SCHEMA; -- Physical_component_feature_mim
(*
© ISO 2018 — All rights reserved