Application module: Assembly module with cable component ISO/TS 10303-1644:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definition
   4.3 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definition
     5.2.2 MIM subtype constraint definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

EXPRESS specification:

*)
SCHEMA Assembly_module_with_cable_component_mim;

USE FROM Assembly_module_design_mim;    --  ISO/TS 10303-1636

USE FROM Cable_mim;    --  ISO/TS 10303-1653
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Assembly_module_design_mim ISO/TS 10303-1636
Cable_mim ISO/TS 10303-1653

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definition

This subclause specifies the MIM entity for this module. The MIM entity and definition is specified below.

5.2.1.1 cable_component   EXPRESS-G

A cable_component is a type of physical_component that implements the ARM concept of Cable_component

EXPRESS specification:

*)
ENTITY cable_component
  SUBTYPE OF (physical_component);
END_ENTITY;
(*

5.2.2 MIM subtype constraint definition

This subclause specifies the MIM subtype constraint for this module. The subtype constraint places a constraint on the possible super-type / subtype instantiations. The MIM subtype constraint and definition is specified below.

5.2.2.1 amwcc_shape_aspect_subtypes   EXPRESS-G

The amwcc_shape_aspect_subtypes constraint specifies a constraint that applies to instances of shape_aspect and enforces the rule that its subtypes assembly_module_terminal, cable_terminal and packaged_part_terminal are exclusive.

EXPRESS specification:

*)
SUBTYPE_CONSTRAINT amwcc_shape_aspect_subtypes FOR shape_aspect;
  ONEOF (assembly_module_terminal,
         cable_terminal,
         packaged_part_terminal);
END_SUBTYPE_CONSTRAINT;
(*



*)
END_SCHEMA;  -- Assembly_module_with_cable_component_mim
(*


© ISO 2018 — All rights reserved