Application module: Assembly module macro definition ISO/TS 10303-1637:2014-02(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARM
   4.2 ARM entity definitions
   4.3 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definition
     5.2.2 MIM subtype constraint definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

EXPRESS specification:

*)
SCHEMA Assembly_module_macro_definition_mim;

USE FROM Interconnect_module_with_macros_mim;    --  ISO/TS 10303-1687
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Interconnect_module_with_macros_mim ISO/TS 10303-1687

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definition

This subclause specifies the MIM entity for this module. The MIM entity and definition is specified below.

5.2.1.1 assembly_module_macro_terminal   EXPRESS-G

An assembly_module_macro_terminal is a type of assembly_module_terminal that implement the ARM concept of Assembly_module_macro_terminal

EXPRESS specification:

*)
ENTITY assembly_module_macro_terminal
  SUBTYPE OF (assembly_module_terminal);
END_ENTITY;
(*

5.2.2 MIM subtype constraint definition

This subclause specifies the MIM subtype constraint for this module. The subtype constraint places a constraint on the possible super-type / subtype instantiations. The MIM subtype constraint and definition is specified below.

5.2.2.1 assembly_module_terminal_subtypes   EXPRESS-G

An assembly_module_terminal_subtypes constraint specifies a constraint that applies to instances of subtypes of assembly_module_terminal.

EXPRESS specification:

*)
SUBTYPE_CONSTRAINT assembly_module_terminal_subtypes FOR assembly_module_terminal;
  ONEOF (assembly_module_interface_terminal,
         assembly_module_macro_terminal);
END_SUBTYPE_CONSTRAINT;
(*



*)
END_SCHEMA;  -- Assembly_module_macro_definition_mim
(*


© ISO 2014 — All rights reserved