Application module: Mechanical design features and requirements ISO/TS 10303-1846:2021(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM function definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definitions
     5.2.2 MIM entity definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious pageNext pageLast page
Figure C.4 — ARM entity level EXPRESS-G diagram 3 of 6 ./armexpg2.htm ./armexpg6.htm ./armexpg2.htm ./armexpg2.htm ./armexpg6.htm ./armexpg2.htm ./armexpg5.htm ./armexpg5.htm ./armexpg2.htm ./armexpg2.htm ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_length_data_element ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_length_data_element ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.angle_plus_minus_bounds ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.angle_plus_minus_bounds ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_length_data_element ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_length_data_element ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_length_data_element ../elemental_geometric_shape/sys/4_info_reqs.htm#elemental_geometric_shape_arm.geometric_model ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_angle_data_element ../elemental_geometric_shape/sys/4_info_reqs.htm#elemental_geometric_shape_arm.geometric_model ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.length_plus_minus_bounds ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.positive_angle_data_element ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.length_plus_minus_bounds ../mechanical_design_features_and_requirements/sys/4_info_reqs.htm#mechanical_design_features_and_requirements_arm.md_countersink_hole_definition ../mechanical_design_features_and_requirements/sys/4_info_reqs.htm#mechanical_design_features_and_requirements_arm.md_counterdrill_hole_definition


Figure C.4 — ARM entity level EXPRESS-G diagram 3 of 6


© ISO 2021 — All rights reserved