Application module: Fabrication technology ISO/TS 10303-1670:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM function definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definitions
     5.2.2 MIM entity definitions
     5.2.3 MIM subtype constraint definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure C.6 — ARM entity level EXPRESS-G diagram 5 of 5 ../fabrication_technology/sys/4_info_reqs.htm#fabrication_technology_arm.ft_property_assignment_select ./armexpg5.htm ./armexpg3.htm ./armexpg5.htm ./armexpg4.htm ./armexpg3.htm ./armexpg5.htm ./armexpg2.htm ./armexpg5.htm ./armexpg3.htm ../requirement_decomposition/sys/4_info_reqs.htm#requirement_decomposition_arm.predefined_requirement_view_definition ../generic_material_aspects/sys/4_info_reqs.htm#generic_material_aspects_arm.material_identification ../extended_measure_representation/sys/4_info_reqs.htm#extended_measure_representation_arm.value_range ../property_assignment/sys/4_info_reqs.htm#property_assignment_arm.property_assignment_select ../characteristic/sys/4_info_reqs.htm#characteristic_arm.tolerance_characteristic ../specification_document/sys/4_info_reqs.htm#specification_document_arm.test_specification ../requirement_decomposition/sys/4_info_reqs.htm#requirement_decomposition_arm.predefined_requirement_view_definition ../fabrication_technology/sys/4_info_reqs.htm#fabrication_technology_arm.passage_deposition_material_identification ../fabrication_technology/sys/4_info_reqs.htm#fabrication_technology_arm.impedance_measurement_setup_requirement ../fabrication_technology/sys/4_info_reqs.htm#fabrication_technology_arm.impedance_requirement ../fabrication_technology/sys/4_info_reqs.htm#fabrication_technology_arm.passage_filling_material_identification


Figure C.6 — ARM entity level EXPRESS-G diagram 5 of 5


© ISO 2018 — All rights reserved