Application module: Assembly module with macro component ISO/TS 10303-1640:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

EXPRESS specification:

*)
SCHEMA Assembly_module_with_macro_component_mim;

USE FROM Assembly_module_macro_definition_mim;    --  ISO/TS 10303-1637

USE FROM Assembly_module_with_subassembly_mim;    --  ISO/TS 10303-1641
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Assembly_module_macro_definition_mim ISO/TS 10303-1637
Assembly_module_with_subassembly_mim ISO/TS 10303-1641

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definitions

This subclause specifies the MIM entities for this module. The MIM entities and definitions are specified below.

5.2.1.1 assembly_module_macro_component   EXPRESS-G

An assembly_module_macro_component is a type of physical_component that implements the ARM concept of Assembly_module_macro_component.

EXPRESS specification:

*)
ENTITY assembly_module_macro_component
  SUBTYPE OF (physical_component);
END_ENTITY;
(*

5.2.1.2 assembly_module_macro_component_join_terminal   EXPRESS-G

An assembly_module_macro_component_join_terminal is a type of physical_component_terminal that implements the ARM concept of Assembly_module_macro_component_join_terminal.

EXPRESS specification:

*)
ENTITY assembly_module_macro_component_join_terminal
  SUBTYPE OF (physical_component_terminal);
END_ENTITY;
(*



*)
END_SCHEMA;  -- Assembly_module_with_macro_component_mim
(*


© ISO 2018 — All rights reserved