Application module: Shape parameters ISO/TS 10303-1743:2010-08(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARM
   4.2 ARM type definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Contents

1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms
4 Information requirements
    4.1 Required AM ARM
    4.2 ARM type definitions
          4.2.1 application_environment
          4.2.2 keepout_product_design_object_category
          4.2.3 material_condition
          4.2.4 material_condition_property_names
          4.2.5 physical_unit_shape_model_select
          4.2.6 predefined_keepout_purpose
5 Module interpreted model
    5.1 Mapping specification
    5.2 MIM EXPRESS short listing
      5.2.1 MIM entity definition
          5.2.1.1 keepout_design_object_category
Annex A MIM short names
Annex B Information object registration
   B.1 Document identification
   B.2 Schema identification
Annex C ARM EXPRESS-G
Annex D MIM EXPRESS-G
Annex E Computer interpretable listings
Bibliography
Index

Figures

Figure C.1 — ARM schema level EXPRESS-G diagram 1 of 1
Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1
Figure D.1 — MIM schema level EXPRESS-G diagram 1 of 1
Figure D.2 — MIM entity level EXPRESS-G diagram 1 of 1

Tables

Table A.1 — MIM short names of entities
Table E.1 — ARM and MIM EXPRESS listings


© ISO 2010 — All rights reserved