Application module: Assembly module with cable component 2D ISO/TS 10303-1638:2010-03(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

EXPRESS specification:

*)
SCHEMA Assembly_module_with_cable_component_2d_mim;

USE FROM Assembly_module_with_cable_component_mim;    --  ISO/TS 10303-1644

USE FROM Physical_unit_2d_design_view_mim;    --  ISO/TS 10303-1724
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Assembly_module_with_cable_component_mim ISO/TS 10303-1644
Physical_unit_2d_design_view_mim ISO/TS 10303-1724

NOTE 2   See Annex D, Figure D.1 for a graphical representation of this schema.



*)
END_SCHEMA;  -- Assembly_module_with_cable_component_2d_mim
(*


© ISO 2009 — All rights reserved