Application interpreted construct: Draughting annotation ISO 10303-504:2011(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 EXPRESS short listing
   4.1 General
   4.2 Fundamental concepts and assumptions
   4.3 Draughting annotation type definition
   4.4 Draughting annotation entity definitions
   4.5 Draughting annotation function definitions

A Short names of entities
B Information object registration
C Computer interpretable listings
D EXPRESS-G diagrams
Bibliography
Index

Annex C
(informative)

Computer interpretable listings

This annex references a listing of the EXPRESS entity names and corresponding short names as specified or referenced in this part of ISO 10303. It also provides a listing of each EXPRESS schema specified in this part of ISO 10303 without comments or other explanatory text. These listings are available in computer-interpretable form in Table C.1 and can be found at the following URLs:

   Short names: http://www.tc184-sc4.org/Short_Names/
   EXPRESS: http://www.tc184-sc4.org/EXPRESS/

Table C.1 — EXPRESS listings

HTML file ASCII file Combined ASCII file
aic_draughting_annotation.htm aic_draughting_annotation.exp ISO TC184/SC4/WG12 N6165

If there is difficulty accessing these sites, contact ISO Central Secretariat or contact the ISO TC184/SC4 Secretariat directly at: sc4sec@tc184-sc4.org.

NOTE  The information provided in computer-interpretable form at the above URLs is informative. The information that is contained in the body of this part of ISO 10303 is normative.



© ISO 2011 — All rights reserved