|
|
Application module:
Solid model |
ISO/TS 10303-1793:2010-07(E)
© ISO
|
This clause specifies the information requirements for the
Solid model
application module. The information requirements are specified as the
Application Reference Model (ARM) of this application module.
NOTE 1 A graphical representation of the information
requirements is given in
Annex C.
NOTE 2 The mapping specification is specified in
5.1. It shows how
the information requirements are met by using common resources and
constructs defined or imported in the MIM schema of this application
module.
This clause defines the information requirements to which implementations shall
conform using the EXPRESS language as defined in ISO 10303-11.
The following begins the
Solid_model_arm
schema and identifies the necessary external references.
EXPRESS specification:
*)
SCHEMA Solid_model_arm;
(*
The following EXPRESS interface statement specifies the elements
imported from the ARM of another application module.
EXPRESS specification:
*)
USE FROM
Elemental_geometric_shape_arm;
--
ISO/TS 10303-1004
(*
NOTE 1
The schemas referenced above are specified in the following
part of ISO 10303:
| Elemental_geometric_shape_arm |
ISO/TS 10303-1004 |
NOTE 2
See Annex C,
Figures
C.1and C.2
for a graphical representation of this schema.
This subclause specifies the ARM entity for this
module. The ARM entity is an atomic element that
embodies a unique application concept and contains attributes
specifying the data elements of the entity. The ARM
entity and definition is specified below.
A Solid_model is a type of Detailed_geometric_model_element
that is a complete representation of the nominal shape of a product. It is bounded and all points in the interior are connected,
Any point in the context of the model can be classified as being inside, outside or on the boundary of the Solid_model.
EXPRESS specification:
*)
ENTITY Solid_model
SUBTYPE OF (Detailed_geometric_model_element);
END_ENTITY;
(*
*)
END_SCHEMA; -- Solid_model_arm
(*
© ISO 2010 — All rights reserved
