Application module: Schematic drawing ISO/TS 10303-1204:2005(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1 ../schematic_element/sys/4_info_reqs.htm#schematic_element_arm.schematic_element_definition ../drawing_structure_and_administration/sys/4_info_reqs.htm#drawing_structure_and_administration_arm.drawing_sheet_revision ../foundation_representation/sys/4_info_reqs.htm#foundation_representation_arm.representation_relationship sys/4_info_reqs.htm#schematic_drawing_arm.intra_page_connector sys/4_info_reqs.htm#schematic_drawing_arm.off_page_connector sys/4_info_reqs.htm#schematic_drawing_arm.on_page_connector sys/4_info_reqs.htm#schematic_drawing_arm.page_connector sys/4_info_reqs.htm#schematic_drawing_arm.schematic_drawing sys/4_info_reqs.htm#schematic_drawing_arm.reference_between_page_connectors


Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1


© ISO 2005 — All rights reserved