Application module: Mechanical design geometric presentation ISO/TS 10303-1313:2008(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Annex B
(normative)

Information object registration

B.1 Document identification

To provide for unambiguous identification of an information object in an open system, the object identifier

{ iso standard 10303 part(1313) version(1) }

is assigned to this part of ISO 10303. The meaning of this value is defined in ISO/IEC 8824-1, and is described in ISO 10303-1.

B.2 Schema identification

B.2.1 Mechanical_design_geometric_presentation_arm schema identification

To provide for unambiguous identification of the schema specifications given in this application module in an open information system, the object identifiers are assigned as follows:

{ iso standard 10303 part(1313) version(1) schema(1) mechanical-design-geometric-presentation-arm(1) }

is assigned to the Mechanical_design_geometric_presentation_arm schema. The meaning of this value is defined in ISO/IEC 8824-1, and is described in ISO 10303-1.

B.2.2 Mechanical_design_geometric_presentation_mim schema identification

To provide for unambiguous identification of the schema specifications given in this application module in an open information system, the object identifiers are assigned as follows:

{ iso standard 10303 part(1313) version(1) schema(1) mechanical-design-geometric-presentation-mim(2) }

is assigned to the Mechanical_design_geometric_presentation_mim schema. The meaning of this value is defined in ISO/IEC 8824-1, and is described in ISO 10303-1.



© ISO 2008 — All rights reserved