Application module: Geometric tolerance ISO/TS 10303-1051:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definitions
   4.5 ARM function definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definitions
     5.2.2 MIM function definitions
     5.2.3 MIM rule definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious pageNext pageLast page
Figure C.5 — ARM entity level EXPRESS-G diagram 4 of 5 ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.tolerance_zone_target ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.directed_or_oriented_geometric_tolerance_select ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg6.htm ./armexpg3.htm ./armexpg6.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg3.htm ./armexpg6.htm ./armexpg4.htm ./armexpg2.htm ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.angle_data_element ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.dimensional_location ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.dimensional_size ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.directed_tolerance_zone_type ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.tolerance_zone_type ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.oriented_tolerance_zone_type ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.directed_tolerance_zone ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.oriented_tolerance_zone ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.tolerance_zone ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.directed_or_oriented_tolerance_zone ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.tolerance_zone_with_datum ../geometric_tolerance/sys/4_info_reqs.htm#geometric_tolerance_arm.affected_plane_tolerance_zone


Figure C.5 — ARM entity level EXPRESS-G diagram 4 of 5


© ISO 2019 — All rights reserved