Application module: Edge shape feature ISO/TS 10303-1673:2006(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definition
   4.3 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1 ../characteristic/sys/4_info_reqs.htm#characteristic_arm.tolerance_characteristic ../layered_2d_shape/sys/4_info_reqs.htm#layered_2d_shape_arm.planar_shape_model ../characteristic/sys/4_info_reqs.htm#characteristic_arm.length_tolerance_characteristic ../edge_shape_feature/sys/4_info_reqs.htm#edge_shape_feature_arm.board_side ../edge_shape_feature/sys/4_info_reqs.htm#edge_shape_feature_arm.step_edge_feature_shape_model ../edge_shape_feature/sys/4_info_reqs.htm#edge_shape_feature_arm.bevel_edge_feature_shape_model ../edge_shape_feature/sys/4_info_reqs.htm#edge_shape_feature_arm.edge_shape_model ../edge_shape_feature/sys/4_info_reqs.htm#edge_shape_feature_arm.radius_edge_feature_shape_model


Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1


© ISO 2006 — All rights reserved