5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

• use of a supertype entity does not make applicable any of its specializations, unless the specialization is also imported in the MIM schema;
• use of a SELECT type does not make applicable any of its listed types unless the listed type is also imported in the MIM schema.

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

USE FROM Construction_geometry_mim;    --  ISO/TS 10303-1131



USE FROM shape_aspect_definition_schema    --  ISO 10303-47
  (apex,
   centre_of_symmetry,
   derived_shape_aspect,
   extension,
   geometric_alignment,
   geometric_intersection,
   parallel_offset,
   perpendicular_to,
   shape_aspect_deriving_relationship,
   tangent);



USE FROM Shape_property_assignment_mim;    --  ISO/TS 10303-1032



USE FROM Value_with_unit_mim;    --  ISO/TS 10303-1054
(*



NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Construction_geometry_mim	ISO/TS 10303-1131
shape_aspect_definition_schema	ISO 10303-47
Shape_property_assignment_mim	ISO/TS 10303-1032
Value_with_unit_mim	ISO/TS 10303-1054

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM type definition

This subclause specifies the MIM type for this application module. The MIM type and definition is specified below.

5.2.1.1 dse_shape_model   

The dse_shape_model type is an extension of the shape_model type. It adds the data type constructive_geometry_representation to the list of alternate data types.

EXPRESS specification:

*)
TYPE dse_shape_model = SELECT BASED_ON shape_model WITH
   (constructive_geometry_representation);
END_TYPE;
(*

© ISO 2018 — All rights reserved