Application module: Default tolerance ISO/TS 10303-1052:2014-02(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition
     5.2.2 MIM entity definitions
     5.2.3 MIM function definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Application module implementation and usage guide
G Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1 ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.general_tolerance_table_select ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.limit_select ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.cell_entry_select ../default_setting_association/sys/4_info_reqs.htm#default_setting_association_arm.default_shape_property ../document_and_version_identification/sys/4_info_reqs.htm#document_and_version_identification_arm.document ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../document_and_version_identification/sys/4_info_reqs.htm#document_and_version_identification_arm.document_version ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.tolerance_table_cell ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.plus_minus_toleranced_datum ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.number_of_decimal_places ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.upper_lower_limit ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.general_tolerance_table ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.significant_number_of_digits ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.general_tolerances ../default_tolerance/sys/4_info_reqs.htm#default_tolerance_arm.upper_lower_toleranced_datum


Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1


© ISO 2014 — All rights reserved